Designed to fix Decathlon snowboard bindings on any snowboard (excluding Burton with "channel").
8 screws and 8 washers.
Sold with thread-locking adhesive to prevent them from loosening.
Phillips screwdriver, ideally PZ3 or PH3.
|Compatibility with bindings||Important: these screws are suitable for most bindings, but you must check that the disk on your binding is not too thin or too thick. To do this, remove your binding and take the central disc, place 1 screw + 1 washer in one of the housings. Measure the length of screw protruding from the disc. If this length is greater than 6 mm after tightening, you will deform the base of your snowboard in front of each screw => do not mount these screws on this binding.|
|Risk if your binding disk is too thin for these screws||The screws will be too long, and will reach the bottom of your board insert, force on the base and will deform it.|
|Risk if your binding disk is too thick for these screws||The screws will be too short. At best, you wont be able to screw them in, but the worst scenario is that you can only screw in 1 or 2 threads. Then you will be in danger, as the screw's resistance will be lower and you risk a binding being ripped our when riding.|
|MRP||₹ 599 inclusive of all taxes|