Made for We have designed this pole for occasional walkers who want to keep their balance during their outings in rough terrain. Already equipped for the mountains: longer handle for banking terrain, adjustable wrist strap. And the same simple Push-pin adjustment system.
This model is designed and validated by our team, at the foot of the Mont Blanc.
This model uses the chassis of the A100, which we have "boosted" to get it ready to take on the mountains!
It retains the push-pin adjustment system and over-sized tubes. However, it can be set higher (130 cm), has an adjustable wrist strap, essential to lean on it, a long foam handle for multi-position grip and a tungsten carbide tip to withstand rock.
How to adjust your poles to the correct length?
Hold the poles with your arms bent at a right angle. To adjust the length: press the button to release it from the hole, slide the tube until the button reaches the hole at the desired length.
Use the line printed on the lower tube to align the button with the holes.
Never go over the STOP line to avoid breaking the pole.
Directions for use
These hiking poles are designed to help you balance, propel yourself and spread the effort between the arms and legs.
To increase safety, before you start and at regular intervals, check your pole's locking mechanism by pressing down hard on it.
Do not put them on backpacks in stormy weather.
Maintaining your poles properly enable you to maintain optimal function and increases their lifespan.
After use, if water has got into the pole, take the parts apart and allow to dry. Clean any dust and mud with water or without, with a soft brush or paintbrush.
Once dry, you can reassemble the parts. We recommend that you do not try to oil or grease them.
Store the poles without tightening the adjustment system, to avoid stress and retain their hold power. Store poles in a dry place.
To set our thresholds, we have measured the stresses on the poles in the most demanding situations. During the design stage, each model passes laboratory tests that reproduce these stresses; etc.) until rupture. We also tests parts separately (tightening power, tearing, etc). Finally, these tests are regularly repeated during production to guarantee constant quality.